Introduction:
The OSE 450 set is a fiber optic receiver manufactured by Langer-EMV in Germany and distributed by EUTTEST, which can transmit digital signals without power at 50 Mbps to an external oscilloscope for display and analysis.
Component Description:
OSE 450 Transmits the digital signals from the disturbed subject to an oscilloscope. It has four separate sensors for each of the four digital signals in the subject. It is connected to a receiver end of the oscilloscope through four optical fibers. The probe converts the logic signals measured from the subject into optical signals. A variety of sensors are available, which have different measurement ranges. At the time of booking, sensors of types S21,S31 and S32 can be selected. The optical signals obtained by the sensors are transmitted via fiber optics to the optical input of the oscilloscope, which converts the optical signals into electrical signals; the oscilloscope can display these signals and use them to control other equipment. The system is suitable for signal monitoring in absorbing outdoor or EMC spaces. It can also optimize the EMC of hardware and software.
S25 The type transducer is a digital probe that transmits digital signals from the test equipment without reaction during a burst sequence test. It is used by attaching it to the circuit board of the test equipment and is powered by the test equipment. The digital signal is converted to an optical signal in the transducer and transmitted via fiber optics to a receiver or oscilloscope.
Technical parameters:
<<<<提醒:左右滑动表格>>>>OE 450 Optical Receiver | |
Transmission range | DC-50 Mbps |
Optical input: fiber optic | 4 x 2.2 mm Ø |
optical interface | Ø 2.2 mm |
Supply Voltage | 12 V / 100 mA |
output interface | 4 x BNC-Stecker, 5 V HCMOS |
S25 Optical Sensor | |
Transmission range | DC-50 Mbps |
optical interface | Ø 2.2 mm |
Supply Voltage | 3 V-5 V |
Current Input | 30 mA |
Boxing list for OSE 450 set:
- 1x OE 450 , Optical Receiver SMA
- 4x S25 , Optical Sensor (50 Mbps)
- 4x LWL Ø 2.2 mm 6 m , 6m fiber optics
- 1x NT FRI EU
- 1x OSE 450 case , System case SMA
- 1x OSE 450 qg , SMA
- 1x OSE 450 acc , SMA
- 1x Digital m
Usage:

Use of the OE 450 with the E1 Development System and External Oscilloscope

S25 Method of connecting chip pins