Introduction：
The H3 set is a magnetic and electric field probe set produced by langer emv, Germany and distributed by EUTTEST Shenzhen. The H3 set offers different types of field source tips for different measurement tasks. The tips allow the localization of weak points with millimetre accuracy and are used to detect critical connections on defined interference paths, such as components, wires or IC pins.
Dimensions of all probes:
The H3 set is a combination set containing all the probes in the table below, note: the size of the probes reflects the resolution to a certain extent.
<<<<提醒：左右滑动表格>>>>| BS 02-h | > 5 cm |
| BS 04DB-h | 1 mm - 3 mm |
| BS 05DB-h | 1 mm - 3 mm |
| BS 05DU-h | millimeters |
| ES 00-h | 1~15cm |
| ES 01-h | 5~10cm |
| ES 02-h | sheet electric field |
| ES 05D-h | PCB Alignment |
| ES 08D-h | Chip Pins |
Boxing list for H3 set:
- 1x BS 02-h, magnetic field source
- 1x BS 04DB-h, magnetic field source
- 1x BS 05DB-h, magnetic field source
- 1x BS 05DU-h, magnetic field source
- 1x ES 00-h, electric field source
- 1x ES 01-h, electric field source
- 1x ES 02-h, electric field source
- 1x ES 05D-h, electric field source
- 1x ES 08D-h, electric field source
- 1x HV SHV-SMB 1 m
- 1x H case, System case
- 1x H3 m, H3 Series Operating Instructions
HV SHV-SMB 1 m connector (for use with EFT generator)
Other options (optional)
"HV FI SMB 1 m" - for use with the EMTEST EFT signal generator:
"HV FI SMB 1 m" - for use with the EMTEST EFT signal generator:
The high voltage cable "HV FI SMB 1 m" is a coaxial cable with a wave impedance of 50 Ω. The cable is terminated with a Fischer plug S103A023 and a special SMB plug from Langer EMC-Technik GmbH. The Fischer plug S103A023 can be inserted into a generator with Fischer jack D103A023. The high flexibility of this high voltage cable makes it particularly suitable for the connection of hand-held field source probes (H3 series, H2 series, electrically fast transient pulse groups IC magnetic field sources).
H3 set for use with pulse train generators
