Introduction：
F-170710-1005-1 is an EMI monitoring current probe manufactured by FCC (Fischer Custom Communications, Inc.) and authorized for sale by EUTTEST Shenzhen. F-170710-1005-1 can be used for testing standards: MIL Std 461F CS114, MIL-Std 461F CS115, MIL-Std 461F CS116, DO-160 section 20 and CISPR 32.
Meets criteria:
The F-170710-1005-1 can be used to test current limits at 150kHz-30MHz on interconnecting cables for CISPR15-2018 as well as the F-170705-1005-1. The F-170710-1005-1 has a smaller measurable EUT current and is cheaper, please contact EUTTEST for a quote. For details of CISPR15 standard test content, please refer to CISPR15 standard Table 6 - Disturbance current limits at local wired ports: local wired portsother than electrical power Disturbance current limits at local wired ports: local wired portsother than electrical power supply interface of ELV lamp
F-170710-1005-1 can also be used to test CISPR32, GJB151B-2013 standards, contact us for more information.
Differences between the two probes:
F-170705-1005-1 It can pass a high current of 750A (DC-400Hz) and can test 67mm cables at the same time, which is expensive.
F-170710-1005-1 can pass a current of 50A (DC-400Hz) and can test a cable of 32mm at the same time (this product).
The main technical parameters of F-170710-1005-1:
Available frequency range: 10 kHz-400 MHz
Internal ring diameter: 32mm
External ring diameter: 71mm
Height: 19mm;
Typical value ZtΩ(1): 0.35;
Typical dBΩ: -9 ;
Connector: N, 50 ohms;
Rated power current value: 50A (DC - 400 Hz);
RF (CW continuous wave): 2A;
Peak pulse current (2): 100A;
1: Calibrate the probe with a 50Ω+j0Ω load impedance.
2: Depends on pulse width and pulse repetition rate.
F-170710-1005-1 Calibration Fixture:
fcc-mpcf-3-32/71/19
F-170710-1005-1 Transmission Impedance Graphs
F-170710-1005-1 Transmission Impedance Graphs
