Introduction：
The F-14 is a 500kHz current probe manufactured by FCC (Fischer Custom Communications, Inc.) and authorized for sale by EUTTEST in Shenzhen, China. It is a clamp-on probe wrapped in a metal casing and can be used to measure high-frequency EMI currents on cables and transmission lines. It can be used to measure currents on 50 Hz, 60 Hz and 400 Hz power lines. 400 Amp (DC-400 Hz) primary supply current will not change the transmission impedance, and it can also be used to measure conducted emissions and to study low level harmonics. The tested RF current will be fed back to the receiver or spectrometer display via the RF cable.
The maximum CW continuous wave current of the F-14 is only 5A, so if you need to pass a larger current, please select it:F-14A Continuous wave current 50A The
Technical parameters：
<<<<提醒：左右滑动表格>>>>| Model number | F-14 |
| Product name | 500kHz current probe |
| manufacturer | U.S. FCC |
| agent | Shenzhen EUTTEST |
| Available frequency range | 10Hz - 500kHz |
| Internal Ring Diameter | 32 mm |
| External ring diameter | 94 mm |
| high degree | 64mm |
| Typical ZtΩ | 0.12 |
| Typical dBΩ | -18 |
| connector | N Female, 50 Ohm |
| industrial frequency current | 400 A (DC - 400 Hz) |
| Continuous wave current | 5A |
| peak pulse current (physics) | 500A 1: Calibrate the probe with a 50Ω+j0Ω load impedance. 2: Depends on pulse width and pulse repetition rate. |
| Optional calibration fixture | fcc-mpcf-1-32/94/64 |
| packing list | One probe; One copy of the instruction manual; One copy of factory calibration data; One hard plastic case; |
Transmission impedance graph.
(Used to test corrections, contact EUTTEST for more information on usage)
Transmission Impedance Curve
FCC: Product specifications are subject to change without notice.
